Uncredited photos on this page taken by: Nathan Holth. Unless stated in a caption, all photos are Copyright with All Rights Reserved. Learn about reuse of our photos.
Photo Credit: Julie Bowers
Photos of Nels Raynor, President of Bach Ornamental and Structural Steel of Holt, Michigan who undertook the recovery and restoration of the bridge.
Photo Credit: Julie Bowers
Photos of Shane Milliken, who also works for Bach Ornamental and Structural Steel.
Photo Credit: Julie Bowers
View of the piers missing their bridge.
Photo Credit: Julie Bowers
The piers appear largely undamaged.
Photo Credit: Julie Bowers
A large portion of the bridge lays downstream in the river.
Photo Credit: Julie Bowers
Overview of the area where a large portion of the bridge ended up.
Photo Credit: Julie Bowers
Some of the damage to the members shows the work that awaits during restoration.
Photo Credit: Julie Bowers
Work begins on removing splice plate rivets on the top chord, to separate the chord into smaller sections to transport.
Photo Credit: Julie Bowers
Preparing to lift a top chord section out.
Photo Credit: Julie Bowers
Working to separate the top chord at the vertical member connection.
Photo Credit: Julie Bowers
Lifting a vertical member/outrigger.
Photo Credit: Julie Bowers
Lifting top chord sections.
Photo Credit: Julie Bowers
Separating the parts of bottom chord connections.
Photo Credit: Julie Bowers
Navigating the tangled mess.
Photo Credit: Julie Bowers
Lifting bottom chord sections out.
Photo Credit: Julie Bowers
Hooking onto and lifting a section of the deck.
Photo Credit: Julie Bowers
Fishing for bridge parts.
Photo Credit: Julie Bowers
Fishing a top chord section out.
Photo Credit: Julie Bowers
Lifting some of the deck wood out.
Photo Credit: Julie Bowers
Fishing various parts of the bridge out.
Photo Credit: Julie Bowers
A vertical member/outrigger is lifted out.
Photo Credit: Julie Bowers
Bottom chord section and badly damaged vertical member/outrigger is lifted out.
Photo Credit: Julie Bowers
Searching for and lifting out bottom chord sections.
Photo Credit: Julie Bowers
Getting pin nuts that may have not been turned for over a century is not as difficult as it might seem. Simply heat the nut, which causes the metal of the nut to expand. Here, the removal of a nut for a bottom chord pin connection is to be removed to separate the bottom chord into smaller sections for transport.
Photo Credit: Julie Bowers
Once heated, the nut will turn.
Photo Credit: Julie Bowers
Here the nut has been removed, the pin remains in place.
Photo Credit: Julie Bowers
If the pin is stuck or frozen in place, a pneumatic hammer can be used to safely push it out, which was the case here.
Photo Credit: Julie Bowers
Here, the bottom chord connection is shown with the pin removed.
Photo Credit: Julie Bowers
Some of the top chord box beams had mud inside, so they were dipped back in the water to wash them out.
Photo Credit: Julie Bowers
A top chord section is loaded for transport.
Photo Credit: Julie Bowers
A damselfly watches the events at the site.